Starting The Engine; Using The Self-Propel Drive (Self-Propel Model Only) - Toro 29732 Bedienungsanleitung

•
Wet grass or leaves can cause serious injury if
you slip and contact the blade. Avoid mowing in
wet conditions.
•
Use extreme care when approaching blind
corners, shrubs, trees, or other objects that may
block your view.
•
Watch for holes, ruts, bumps, rocks, or other
hidden objects. Uneven terrain could cause a
slip-and-fall accident.
•
Stop the machine and inspect the blades after
striking an object or if there is an abnormal
vibration in the machine. Make all necessary
repairs before resuming operation.
•
Before leaving the operating position, shut off
the engine, remove the ignition key (electric-start
model only), and wait for all moving parts to stop.
•
If the engine has been running the muffler will be
hot and can severely burn you. Keep away from
the hot muffler.
•
Check the grass catcher components and the
discharge guard frequently and replace them with
the manufacturer's recommended parts when
necessary.
•
Use accessories and attachments approved by
the The Toro® Company only.
Slope Safety
•
Mow across the face of slopes; never up and
down. Use extreme caution when changing
direction on slopes.
•
Do not mow on excessively steep slopes. Poor
footing could cause a slip-and-fall accident.
•
Mow with caution near drop-offs, ditches, or
embankments.

Starting the Engine

1. Hold the blade-control bar
the handle.
1. Blade-control bar
2. Insert the key into the electric starter and turn it
(electric-start models only; refer to
pull the recoil-start handle
(Figure 15) against
Figure 15
Figure
(Figure 17).
Note:
attempts, contact an Authorized Service Dealer.
Using the Self-propel Drive
(Self-Propel Model Only)
To operate the self-propel drive, squeeze the
self-propel drive bar
and hold it.
1. Self-propel drive bar
To disengage the self-propel drive, release the
self-propel drive bar.
Note:
The maximum self-propel ground speed is
g014712 fixed. To reduce the ground speed, increase the space
between the self-propel drive bar and the handle.
16) or
11
Figure 16
Figure 17
If the machine does not start after several
(Figure 18) toward the handle
Figure 18
g014717
g014718
g009642