Starting the Engine
1. Hold the blade control bar against the handle
(Figure 12).
2. Pull the recoil starter (Figure 13) or turn the ignition
key as shown in Figure 14 (model 21027 only).
Note: If the mower does not start, contact an
Authorized Service Dealer.
Figure 12
Figure 13
Figure 14
Using the Self-propel Drive
Models 21026 and 21027 only
To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the mower will automatically keep pace with
you (Figure 15).
Stopping the Engine
1. Release the blade control bar (Figure 16).
2. When the engine stops, remove the ignition key
when you leave the mower.
Important: When you release the blade control
bar, both the engine and blade should stop
within 3 seconds. If they do not stop properly,
stop using your mower immediately and contact
an Authorized Service Dealer.
9
Figure 15
Figure 16