Starting The Engine - Toro 53cm Super Recycler 20792 Bedienungsanleitung

•
When you release the blade-control bar, the
engine should shut off and the blade should stop
within 3 seconds. If not, stop using your machine
immediately and contact an Authorized Service
Dealer.
•
Always look down and behind you before moving
the machine in reverse.
•
Operate the machine only in good visibility and
appropriate weather conditions. Do not operate
the machine when there is the risk of lighting.
•
Wet grass or leaves can cause serious injury if
you slip and contact the blade. Mow only in dry
conditions.
•
Use extreme care when approaching blind
corners, shrubs, trees, or other objects that may
block your view.
•
Watch for holes, ruts, bumps, rocks, or other
hidden objects. Uneven terrain could cause a
slip-and-fall accident.
•
Stop the machine and inspect the blades after
striking an object or if there is an abnormal
vibration in the machine. Make all necessary
repairs before resuming operation.
•
Before leaving the operating position, shut off
the engine, remove the electric-start button
(electric-start model only), and wait for all moving
parts to stop.
•
If the engine has been running the muffler will be
hot and can severely burn you. Keep away from
the hot muffler.
•
Check the grass catcher components and the
discharge guard frequently and replace them with
the manufacturer's recommended parts when
necessary.
•
Use accessories and attachments approved by
The Toro® Company only.
Slope Safety
•
Mow across the face of slopes; never up and
down. Use extreme caution when changing
direction on slopes.
•
Do not mow on excessively steep slopes. Poor
footing could cause a slip-and-fall accident.
•
Mow with caution near drop-offs, ditches, or
embankments.

Starting the Engine

You can start the engine using either the electric-start
button (if equipped) or the recoil-start handle.
Starting the Engine Using the
Electric-Start Button
For Electric-Start Models
1. Hold the blade-control bar against the handle
(Figure 15).
1. Blade-control bar
2. Push the electric-start button until the engine
starts (Figure
Note:
If the electric-start button has been
removed, insert it in the electric starter; refer to
Figure 16.
1. Electric starter
2. Electric-start button
Note:
If the machine does not start after several
attempts, contact an Authorized Service Dealer.
12
Figure 15
16).
Figure 16
3. Electric-start button
(installed)
g009546
g020174