Charging The Battery; Replacing The Fuse - Toro 29732 Bedienungsanleitung

Figure 27
5. After draining the used oil, return the machine to
the operating position.
6. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
7. Wait about 3 minutes for the oil to settle in the
engine.
8. Wipe the dipstick clean with a clean cloth.
9. Insert the dipstick into the oil-fill tube, then
remove the dipstick.
10. Read the oil level on the dipstick
•
If the oil level is below the Add mark on the
dipstick, carefully pour a small amount of
oil into the oil-fill tube, wait 3 minutes, and
repeat steps 8
at the Full mark on the dipstick.
•
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level
is at the Full mark on the dipstick.
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
11. Install the dipstick into the oil-fill tube securely.
12. Recycle the used oil properly.

Charging the Battery

Electric-Start Model Only
Service Interval: Every 25 hours
Charge the battery for 24 hours initially, then monthly
(every 25 starts) or as needed. Always use the
charger in a sheltered area and charge the battery at
room temperature (22°C or 70°F) whenever possible.
1. Connect the charger to the wire harness located
below the ignition key
(Figure
through 10 until the oil level is
(Figure 28).
2. Plug the charger into a wall outlet.
Note:
charge, recycle or dispose of the lead-acid
battery according to local codes.
g032764
Note:
Your battery charger may have a 2-color LED
display that indicates the following states of charging:
•
A red light indicates that the charger is charging
the battery.
•
A green light indicates that the charger is fully
charged or the charger is disconnected from the
battery.
•
A flashing light that alternates between red and
green indicates that the battery is nearly fully
charged. This state lasts only a few minutes until
the battery is fully charged.
26).

Replacing the Fuse

Electric-Start Model Only
If the battery does not charge or the engine does not
run with the electric starter, the fuse may be blown.
Replace it with a 40 A plug-in type fuse.
1. Unclip the battery cover and remove it
29).
1. Battery cover
2. Foam
2. Insert the fuse into the fuse holder
17
Figure 28
When the battery no longer holds a
Figure 29
3. Battery
4. Fuse holder
g002889
(Figure
g032021
(Figure 30).