SPORTSTECH KS260 Benutzerhandbuch Seite 18

Step 2
Make sure that both ends of the pull-up bar are extended by identical lengths. Try
pushing the red locking mechanism towards the center on both sides and turning it
in the direction of the arrow to test whether it clicks into place. If this is not the case,
the lengths of the two ends do not match and must be adjusted. Release the locking
mechanism again before you carry out the next assembly step.
When fastening onto the door frame, make sure that the arrows of the locking me-
Step 3
chanism point upwards and that the pull-up bar is in a perfect horizontal orientation
to the floor.
Now turn the main bar in the middle until both ends are extended so far that the
Step 4
device is firmly attached to the door frame.
18