Lcd Tv And Operating Buttons; Viewing The Connections- Back Connectors - Schaub Lorenz LT22-356 DB Bedienungsanleitung

LCD TV and Operating Buttons

FRONT and REAR VIEW

Viewing the Connections- Back Connectors

1. SCART socket inputs or outputs for external devices.
Connect the SCART cable between SCART socket on TV and SCART socket
on your external device (such as a decoder, a VCR or a DVD player).
Note: If an external device is connected via the SCART socket, the TV will
automatically switch to AV mode.
2. PC Input is for connecting a personal computer to the TV set.
Connect the PC cable between the PC INPUT on the TV and the PC output
on your PC. Component Video Inputs (YPbPr) are used for connecting
component video.
You can use PC input to enable YPbPr signal sonnection with a device that
has component output. Connect the YPbPr to PC cable between the PC
INPUT on the TV and the component video outputs of your device. (YPbPr
cable is not supplied)
3. HDMI : HDMI input
HDMI Input is for connecting a device that has an HDMI socket.
Your LCD Television is capable of displaying High Definition pictures from devices such as a High Definition
Satellite Receiver or DVD Player. These devices must be connected via the HDMI sockets or Component Socket.
These sockets can accept either 480i, 480p, 576p, 576i, 720p, 1080i, 1080p signals. No sound connection is
needed for an HDMI to HDMI connection.
4. RF Input connects to an antenna or a cable.
Note that if you use a decoder or a media recorder, you should connect the aerial cable through the device to the
television with an appropriate antenna cable, as shown in the illustration in the following pages.
When you use the wall mount kit (optional) with the LCD TV, we would definitely recommend to plug all your cables into the back of the
LCD before mounting to the wall.
02_MB45_[GB]_1055UK_IDTV_BRONZE11_22855W_10065354_50156390.indd 38 02_MB45_[GB]_1055UK_IDTV_BRONZE11_22855W_10065354_50156390.indd 38
SIDE VIEW
English - 38 -
Control Buttons
1. Up button
2. Down button
3. Programme/Volume / AV
selection button
4. Standby button
Note:You can use "+/-" buttons to change
volume. If you want to change channels,
press P/V/AV button once and then use
"+/-" buttons. If you hold the P/V/AV
button about a few seconds, source OSD
will be displayed. Main menu OSD cannot
be displayed via control buttons.
28.09.2009 17:59:11 28.09.2009 17:59:11