Slave Mode; Music Control - Cameo FLAT PAR CAN TRI 3W Bedienungsanleitung

OPERATION:
AUTO MODE
Press the MODE button repeatedly until "AUTO" appears in the display.
In this operating mode, the light switches automatically between colour
change and colour blending mode. The colour change and/or colour
blending rate is determined by the settings of the respective mode.

SLAVE MODE

Press the MODE button repeatedly until "SLAV" appears in the display.
Connect the slave and the master unit with a DMX cable. Now the slave
unit follows the master unit. Confirm with ENTER.

MUSIC CONTROL

SETUP
Press the MODE button repeatedly until "SU00" appears in the display.
Now the light is controlled by the built-in microphone and follows the beat
of the music. Now press the ENTER button again (all 4 characters blink)
and use the UP and DOWN buttons to set the sensitivity of the microphone
(0 - 99). Confirm with ENTER.
SETUP
DMX MODE SELECTION
Press the MODE button repeatedly until one of the four modes appears in
the display (2Ch, 3Ch1, 3Ch2, 6Ch). Press ENTER (all characters blink) and
use the UP and DOWN buttons to select the desired DMX mode. Confirm
with ENTER.
SETUP
SET DMX START ADDRESS
Press the MODE button repeatedly until "A" and 3 additional characters
appear in the display. Press ENTER (all characters blink) to use the UP and
DOWN buttons to select the desired DMX start address (A001 - A512).
Confirm with ENTER. Note: In order to be able to use the light in DMX
SETUP
mode, the DMX start address mode must be set.
NOTE
Unless one of the 4 buttons is pressed, the LED display switches off
automatically after approx. 1 minute. As soon as one of the four buttons is
pressed, the display switches on again.
11