Local Keypad - Barco Thor Benutzerhandbuch

4.4

Local Keypad

Identification of the buttons
Abbildung 4-4
Functionality of the buttons
Numeric buttons (No.1 - 6)
1
Each Numeric button (reference 1 Abbildung 4-4) can be linked to a macro which allows you to setup the projector to your
requirements with one push of a button. The backlight of the Numeric button is white if a macro is associated with the
Numeric button. The backlight is green if the macro associated with the Numeric button is activated. The backlight is red in
case one of the actions of the macro failed. Inactive Numeric buttons have no backlight.
When the authorization process is activated with the (security) Key button, the backlight of the Numeric buttons changes to
yellow.
Marker area
2
Each Numeric button has a marker area (reference 2 Abbildung 4-4) where you can write down the name of the Macro.
Standby button
3
Pushing the Standby button (reference 3 Abbildung 4-4) for 3 seconds changes the projector mode from Standby mode
(energy saving) to Operational mode or vice versa. The backlight of the Standby button is blinking white or green,
depending on the requested mode. Once the requested mode is reached the backlight will be continuously lit up green in
Operational mode or white in Standby mode.
Enter or leave Standby mode can also be done via a 2 dedicated projector command (USB/Ethernet), or via two predefined
Macros (not editable) with GPIO, or via the Communicator.
During projector initialization the backlight of the Standby button is blinking blue.
In case the Light button and the Standby button continuous lights up red indicates that no lens is installed or that the
ambient temperature inside the Light Processor compartment is exceeded or that the DMD FRONT or DMD BACK
temperature is exceeded.
Star button
4
Star button (reference 4 Abbildung 4-4). Pressing the Star button a few seconds will activate the ICMP reset process.
Light button
5
Light button (reference 5 Abbildung 4-4) switches the lasers ON or OFF.
Pushing the Light button (reference 5 Abbildung 4-4) for 3 seconds will activate or deactivate the lasers of the projector. The
backlight of the Light button is blinking white or green, depending on the requested mode. Once the requested mode is
reached the backlight will be continuously lit up green when the lasers are activated or white when the lasers are deactivated.
In case the Light button and the Standby button continuous lights up red indicates that no lens is installed or that the
ambient temperature inside the Light Processor compartment is exceeded or that the DMD FRONT or DMD BACK
temperature is exceeded.
R5906787 THOR 16/12/2016
1 2
1
2
3
3 4 5
8 9 10
4
5
DOWSER
6
4. Input & Communication
6 7
11 12
FOCUS
SHIFT SHIFT
ZOOM ZOOM
29