Leg Support; Pushing The Wheelchair - B+B Triplex Bedienungsanleitung

TRIPLEX
| Electric Wheelchair
Moving forward:
cautiously forward. The further forward the joystick is moved, the faster
your wheelchair gets. If you release the joystick the wheelchair will
automatically be braked to a stop.
Reversing:
to move in reverse mode, move the joystick cautiously
back. The further back the joystick is moved, the faster your wheelchair
gets. If you release the joystick the wheelchair will automatically be
braked to a stop.
Turning corners:
left or right. This can also be done when the joystick is tilted forwards
or backwards, i.e. while driving backwards or forwards.

4.6. Leg support

Mechanical leg-rests
To make it as easy as possible to enter and leave your wheelchair, the
foot plates can be folded up, or the leg rests can be swung to the side
out of the way or removed.
31
• Open the lock to swing the leg rest to the side (fig. 31).
• The leg rest in the swung-out position can be completely removed
(fig. 32).
• When you want to replace the leg rest, proceed in reverse order.
• Move the leg rest to the forward position until you hear it lock into
place.
32
58
to move forward in a straight line move the joystick
To change direction of travel, tilt the joystick to the
Electric Wheelchair |
Electronic leg support
In order to make getting in and out as easy as possible, you can fold
the foot-plates upwards and pivot the calf rests outwards. You can also
swing out or raise the foot support.
• First remove the connection cable to the foot support.
• To pivot the foot support outwards, open the locking device (fig.
33).
• In the "external position" the foot support can be removed entirely.
• To reassemble the foot support reverse the process.
• Swing the foot support forwards until you hear it click into place.

4.7. Pushing the wheelchair

If you wish to push the wheelchair, the brakes must be unlocked. The
wheelchair is easy to push in free-wheel mode.
Caution! The electromechanical brake is disabled in
this mode.
• Move the unlocking levers up (fig. 34).
• Make sure the unlocking levers are locked into position.
• To lock them again pull the unlocking levers up and they will lock
automatically.
For safety reasons the motor drive is locked in
freewheel mode.
Caution! Danger of fatal injury! The drives must
only be unlocked on level ground.
Bischoff & Bischoff GmbH | 05.10.2020 - Revision: 1
TRIPLEX
33
34
59