Electronic Foot Support; Seat - B+B Triplex Bedienungsanleitung

TRIPLEX
| Electric Wheelchair

3.5.2. Electronic foot support

Length of lower leg support
• The lower leg support can be adjusted from 420 to 580 mm.
• To do so, loosen the two allen screws.
• Adjust to the desired height (fig. 04).
• Tighten the screws again.
• Use medium-strength Loctite to lock screws in place.
04
Angle of foot support
• The angle of the footplate is fully adjustable.
• Undo the screw to the side of the footplate.
• Adjust the footplate to the desired angle (fig. 05).
• Tighten the screw again.
• Use medium-strength Loctite for fixation.
05
Height of the calf pad
• The height of the calf pad is adjustable.
• Undo the screw to the side of the foot support.
• Adjust the calf pad to the desired height (fig. 06).
• Use medium-strength Loctite for fixation.
06
46
Make sure there is an appropriate distance between
foot support and the ground.
Electric Wheelchair |

3.5.3. Seat

Seat depth
• The default setting of the seat depth is 450 mm.
• You can reduce the seat depth to 400 mm. You should then use a
newly fitted seat cushion.
• To adjust the seat depth, undo the fastenings of the back support,
slide it forward and tighten the screws again (fig. 07).
Seat angle - mechanical
This description only applies, if you have a configuration with a
mechanically adjustable seat angle.
• The default setting of the seat angle is 1° backwards.
• The seat angle can be adjusted backward in five steps.
• To do this, undo the fastening screw on the telescopic section at
the front under the seat.
• Remove the screws and adjust the seat to the desired angle (fig.
08).
• Place the screws into the nearest possible hole and tighten them
again.
Angle of the back - mechanical
This description only applies, if you have a configuration with a
mechanically adjustable back angle.
• The angle of the back support of your electrical wheelchair can be
easily adjusted. In addition, you also have the option of entirely
folding down the back support forwards.
• To fold down the back support, remove the fastening pin on the
back support and then fold down the back support. (fig. 09)
• The angle of the back support can be adjusted to four settings.
• Undo the fastening screw on the telescopic section at the back
under the seat.
• Remove the screw and adjust the seat to the desired angle.
• Place the screws into the nearest hole and tighten them again.
Bischoff & Bischoff GmbH | 05.10.2020 - Revision: 1
TRIPLEX
07
08
09
47