Inhaltsverzeichnis; General Information; Hazard Statements; Notes - Grundfos Control CUE Montage- Und Betriebsanleitung

English (GB) Installation and operating instructions
Original installation and operating instructions
These installation and operating instructions describe Grundfos
Control CUE.
Sections 1-3 give the information necessary to be able to install
and start up the product in a safe way.
Sections 4-6 give important information about the product, as well
as technical data and disposal of the product.
CONTENTS
1. General information
1.1 Hazard statements
1.2 Notes
1.3 Scope of these instructions
2. Installation
2.1 Mechanical and electrical installation
3. Commissioning the product
3.1 CUE frequency converter settings
4. Product introduction
4.1 Nameplate
4.2 Type key
4.3 Product range
4.4 Applications
5. Technical data
5.1 Technical specification on the cabinet
5.2 Options for the cabinet range
6. Disposing of the product
Read this document before installing the product.
Installation and operation must comply with local
regulations and accepted codes of good practice.
4

1. General information

1.1 Hazard statements

The symbols and hazard statements below may appear in
Grundfos installation and operating instructions, safety
instructions and service instructions.
DANGER
Indicates a hazardous situation which, if not avoided,
will result in death or serious personal injury.
Page
4
4
WARNING
4
Indicates a hazardous situation which, if not avoided,
4
could result in death or serious personal injury.
5
5
CAUTION
5
Indicates a hazardous situation which, if not avoided,
5
could result in minor or moderate personal injury.
6
6
The hazard statements are structured in the following way:
6
SIGNAL WORD
7
8
Description of hazard
9
Consequence of ignoring the warning.
9
- Action to avoid the hazard.
9

1.2 Notes

10
The symbols and notes below may appear in Grundfos
installation and operating instructions, safety instructions and
service instructions.
Observe these instructions for explosion-proof
products.
A blue or grey circle with a white graphical symbol
indicates that an action must be taken.
A red or grey circle with a diagonal bar, possibly with
a black graphical symbol, indicates that an action
must not be taken or must be stopped.
If these instructions are not observed, it may result in
malfunction or damage to the equipment.
Tips and advice that make the work easier.

1.3 Scope of these instructions

These installation and operating instructions apply to applications
where cabinets with Grundfos CUE is used.