Replacing The Rack Doors; Two-Post Rack Installation; Recommended Tools And Supplies - Dell PowerVault 725N Rack-Installationsanleitung

JO525bk0.book Page 17 Monday, January 27, 2003 12:29 PM

Replacing the Rack Doors

See the procedures for replacing doors in the documentation provided with your rack
cabinet.
CAUTION: Because of the size and weight of the rack cabinet doors, never
attempt to remove or install them by yourself.
This completes the rack installation of your system in a four-post rack cabinet.

Two-Post Rack Installation

The two-post rack kit is used to install a system in a two-post, open-frame relay rack, such as
those found in telecommunications equipment facilities. Both 3-inch and 6-inch wide two-
post racks with universal hole spacing or wide hole spacing are accommodated. You can
install this kit in a center-mount or a flush-mount configuration. The two-post kit
incorporates slide assemblies which enable the system to be pulled out of the rack for
servicing.
You must properly secure the two-post relay rack to the floor, the ceiling or upper wall, and
where applicable, to adjacent racks, using floor and wall fasteners and bracing specified or
approved by the rack manufacturer or by industry standards. See the two-post rack
manufacturer's documentation for warnings before attempting this installation.
CAUTION: Do not attempt to install the system into a two-post, open-frame relay
rack that has not been securely anchored in place. Damage to the system and
personal injury to yourself and to others may result.
See "CAUTION: Safety Instructions" for additional safety information regarding rack
installation.

Recommended Tools and Supplies

• #2 Phillips screwdriver
• 11/32-inch wrench or nut driver (if changing bracket to flush-mount configuration)
• Masking tape or felt-tip pen to mark the mounting holes
Downloaded from www.Manualslib.com manuals search engine
Rack Installation Guide
1-17