Flush-Mount Installation - Dell PowerVault 725N Rack-Installationsanleitung

JO525bk0.book Page 23 Monday, January 27, 2003 12:29 PM
F i g u r e 1 - 1 6 .
12-24 x 0.5-inch pan-head
Phillips screws (1 per side)
holes for stiffening bracket
with 3-inch racks
holes for stiffening bracket
with 6-inch racks
stiffening bracket

Flush-Mount Installation

The two-post rack kit is shipped with the brackets configured for center-mount installation.
To prepare the slide assemblies for flush-mount installation in the two-post rack, perform
the following steps:
Locate the two slide assemblies and place them side by side on a smooth work surface,
1
with the front ends of the slide assemblies toward you and the center brackets facing
upward (see Figure 1-17).
NOTE: To prepare the slide assemblies for flush-mount installation, remove the front
mounting bracket, rotate it 180 degrees, and reinstall it on the opposite slide assembly.
Downloaded from www.Manualslib.com
I n s t a l l i n g t h e S t i f f e n i n g B r a c k e t a n d C a b l e Tr a y
manuals search engine
hooks (4)
slide assemblies (2)
Rack Installation Guide
cable tray
1-23