Operation - HANSGROHE AXOR Uno2 38030000 Montageanleitung

Attention! The fitting must be installed, flushed and
tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slide the fixation piece including the washer
over the threaded pins and tighten the nuts.
4. Connect the supply pipes to the isolation
valves;
cold right - hot left.
5. 38030000 / 38035000: Connect the pull rod
to the pop-up waste.
The hot and cold supplies must be of equal pres-
sures.
Technical Data
This mixer series-produced with waterdim-
mer (flow limiter)
®
Rate of flow with waterdimmer:
Rate of flow without waterdimmer: 14 l/min 0,3 MPa
Operating pressure:
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temperature: 65° C
Test certificate 38030000:
The aerator is not equal to DIN EN 246

Operation

open
English
7 l/min 0,3 MPa
max. 1 MPa
1,6 MPa
max. 80° C
WRAS
close
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled continu-
ous flow heaters if the flow pressure is at least 0,15
MPa.
If the continuous flow heater makes any problems or
there comes not enough water, the flow limiter (6a)
located behind the mousseur must be removed.
To adjust the hot water limiter on single lever mixers,
please see page 14.
No adjustment is necessary when using a continuous
flow water heater.
Spare parts (see page 4)
1 handle
1.1 screw cover
1.2 hollow set screw M6x10 DIN916 96029000
2 flange
3 nut
4 cartridge, assy
5 seal
6 aerator cpl.
7 fixing set
8 connection hose 470 mm
9 pull rod
10 spout cpl. 38030000/38031000 97363000
11 spout cpl. 38035000
Special accessories
X special tool set
(order as an extra)
hot
38094000
96762000
96763000
97209000
96764000
95008000
96911000
13961000
96321000
96657000
97688000
58085000
cold