Operation - HANSGROHE Focus E 31700 Serie Bedienungsanleitung

Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the fixation piece including the washer over
the threaded pins and tighten the nuts.
4. Connect the supply pipes to the isolation valves;
cold right - hot left.
5. 31700XXX/31704000/31720XXX:
Connect the pull rod to the pop-up waste.
The hot and cold water supply's must be of equal
pressures.

Operation

The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Technical Data
Rate of flow
317000000 / 31704000 /
31715000:
Rate of flow 31720000/
31725000:
Operating pressure:
Recommended operating pressure 0,1 - 0,5 MPa
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0, 15 MPa.
To adjust the hot water limiter on single lever mixers,
please see page 23.
No adjustment is necessary when using a continuous
flow water heater.
8
English
Spare parts (see page 5)
1
1.1 screw cover
2
3
4
5
6
7
8
9
10 connection hose 470 mm
12 l/min 0,3 MPa
7 l/min 0,3 MPa
max. 1 MPa
1,6 MPa
max. 80° C
65° C
handle
flange
flange gold plated
nut
cartridge cpl.
aerator cpl. (10)
aerator gold plated
pop up rod
fixing set
connection hose 3/8"
aerator cpl.
31791000
96338000
96656000
96656990
96690000
92730000
13955000
13085990
96657000
96016000
97206000
13085000
96321000