Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Technical Data; Spare Parts - HANSGROHE Mediano 14907000 Montageanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the sink.
3. Slip the plastic washer, the slide washer, the
metall washer and collar nut over the hose and
threaded base and tighten the collar nut by
hand. If there is not enough space, please use
only the slide washer and the metall without the
4. Tighten screws.
5. Connect the connecting hose to the angle
valves;
cold right - hot left.
6. Connect the hose with hose nut, taper sleeve,
disc and washer.
7. Mount the hose weight - be careful by the max.
drawn out, otherwise the hose could be crack.
After the assembly!
8. Dismount the handspray and the filter.
9. Flush through the hose.
10. Cleaning the filter.
11. Mount the filter and the handspray
Large differences in pressure between the hot and
cold water supply should be balanced.

Operation

The mixer is actuated by lifting the lever head.
Swivel to the left = hot water, swivel to the right =
cold water.
The handspray can be drawn approx. 50 cm out of
the arm lining. The spray mode is changed to
showerspray by pressing the front button
top of the sprayhead. By pressing the rear button
or switching off the water, the spray mode changes
to aerated spray.
If the waterflow drops, clean the filter located between
hose and handspray.
6
English

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temperature:
Rate of flow by 3 bars aerated spray:
Rate of flow by 3 bars shower spray:
hot water limiter:
Back flow and vacuum breaker
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
To adjust the hot water limiter on single lever mixers,
please see page 12.
No adjustment is necessary when using a continu-
ous flow water heater.

Spare parts

1
handle
1.1 screw cover
2
flange
3
nut
4
cartridge cpl.
5
locking screw
6
hose 1,25 m
7
handspray assy
8
aerator cpl. (10)
9
fixation set
10
non return valve DW15 (10)
on the
11
seal
12
squeezing connection
max. 10 bars
1,5 - 5 bars
16 bars
max. 80° C
65° C
11 l/min
12 l/min
order separatly
14890000
94186000
96391000
94194000
92730000
96059000
95048000
14893000
13913000
95049000
94074000
95008000
96099000

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis