Using This Unit - Yamaha DPX–1 Bedienungsanleitung

BASIC OPERATION

Using this unit

This section describes the basic projecting operation after installa-
tion and connection have been completed.
Detailed settings must be made for installation, screen, input signal
and so on, by following the menu setting procedure described in
the section starting on page 15.
I Turning on the power
Remove the lens cap before starting any operation of this unit.
1.
Plug the supplied power cord into the AC inlet on the
rear of this unit. Then plug the cord into the wall
outlet.
indicator
STANBY/ON INPUT
LAMP TEMP
/COVER /FAN FILM
Power switch
2.
Turn on the power switch of this unit. The
indicator lights up in red in a few seconds.
3.
Press the STANDBY/ON button, the
flashes in green and the lamp inside this unit lights
up.
The indicator stops flashing and lights steadily after about
30 seconds and this unit is ready for projection.
indicator
(Flashing in green → lights steadily in green)
STANDBY/ON
LAMP
TEMP
/COVER
/FAN
STANDBY/ON
Important
• Never turn off the power switch or unplug this unit
while the indicator is lit or flashing in green.
This causes significant damage to the lamp and
may result in its shorter life or failure.
10
E-
ESCAPE SELECT
PATTERN MENU
AC inlet
indicator
INPUT
PATTERN
AUTO
PATTERN
FILM
PATT
ESCAPE
SELECT
ASPECT
RESET STILL
I Focusing
Press the PATTERN button to project the stored test pattern.
Adjust the lens so that it comes into focus by rotating the focus
ring. The image size can be also adjusted with the zoom ring.
Lens
There are two test patterns. Choose whichever is desired by
pressing the + or – button.
Press the PATTERN button again to close the test pattern.
STANDBY/ON
MENU
INPUT
HIDE
PATTERN
INPUT
TEMP
PATTERN MENU
R
/FAN FILM
Zoom ring
Focus ring
ESCAPE