How To Connect - Yamaha DPX–1 Bedienungsanleitung

CONNECTION

How to connect

• Before making connections, make sure that the power of this unit and other components is turned off.
• Some components require different connection methods and have different jack names. Refer to the operation instructions for each
component to be connected to this unit.
• Plug in this unit correctly to prevent from creating noise or troubles.
I Connecting a video component
There are five types of video connections available on this unit for A/V components as shown in the illustration below. Connect video output
signals from A/V components to this unit by following the illustration below with the correct cables and adapters.
VIDEO
S VIDEO
INPUT A
INPUT B
D4 *
* This connector is designed for the Japanese D format only.
Video pin cable
Video S video
output jack output jack
N Note N
• When connecting A/V component to INPUT A component jacks, make sure to match the Y/P
connected. Also refer to the operation instructions for the A/V component. HD/SYNC and VD need to be connected for RGB video signals in some cases.
8
E-
Input
Composite video
S video
Component video/RGB video
Component video/RGB video
Component video
S video cable
Converting plug
Pin cable
Pin jacks
Component/RGB video output
Video outputs of various A/V components
Type of signal
Pin jack
Mini DIN jack
BNC jack x 3—5
D-Sub 15-pin connector
D4 connector
RGB/YP P /YC C
B R B R
S VIDEO VIDEO INPUT B TRIGGER OUT
INPUT A
G/Y B/P /C R/P /C HD/SYNC VD
B B R R
BNC cable for
component
G/Y B/P /C R/P /C
B B R R
D-Sub
BNC jacks
jack/connector
/P or Y/C
B R
Type of jack
DVI
D4 VIDEO RS-232C
D connector cable
D-Sub monitor cable
D1—D4 output
connector
/C of the A/V component and this unit to be
B R