Yamaha DPX–1 Bedienungsanleitung Seite 21

I 3 <INITIAL>
S
COLOR SYSTEM
Selects the color system when the video signal is input among NTSC, NTSC
PAL60, SECAM. AUTO should normally be selected so that the appropriate color system can be
automatically selected depending on the input signal. However, PAL-M should be selected when the
input signal is PAL-M.
INPUT A SIGNAL S
Selects the type of input signal sent to the INPUT A jacks.
S
INPUT B SIGNAL
Selects the type of input signal sent to the INPUT B jacks.
LANGUAGE S
Selects the language used on the menu.
POWER SAVING
When no signal is received at the input jacks for longer than 15 minutes, this unit automatically turns off
the lamp and enters the standby mode if ON is selected.
S
LAMP RUNNING TIME
Displays the total lamp running time. The lamp running time can be reset on the submenu.
RESET S
Resets all parameters on the menu or parameters in the memory to the factory settings.
I 4 <SETUP>
S
INSTALLATION
There are four methods to install this unit; tabletop or on-ceiling for front or rear projection. The image can
be inverted or rotated according to the setting for the installation method.
SCREEN ASPECT
Selects 4:3 or 16:9 depending on the screen to be used. If 16:9 is selected, vertical adjustment of the image
can be made by changing the value of the item "DIGITAL LENS SHIFT". And automatically makes an
adjustment to project the 4:3 input signal without losing any part of it off screen.
* DIGITAL LENS SHIFT
The image on the screen can be vertically adjusted within a certain range by digital processing. h moves the
image upward and g downward. This adjustment is available only when the screen aspect ratio is set to 16:9.
KEYSTONE
If this unit projects on a the screen with some elevation or depression angle at its installation, the image on
the screen is distorted into a trapezoid. This parameter electrically corrects the distortion. Increase the value
when the upper part of the image is wider. Decrease the value when the lower part if the image is wider.
KEYSTONE MODE
There are two modes; "FULL" that corrects the key stone effect without changing the vertical length of the
image, and "NORMAL" that makes vertical correction by shifting the bottom at the same time. Select the
appropriate mode to make correction depending on your installation.
1Normal correction
This correction shifts the bottom of the projected image to correct
the horizontal distortion.
When the upper part of the image is wider than the
lower part, increase the value to the positive (+)
direction.
When the lower part of the image is wider than the
upper part, decrease the value to the negative (–)
direction.
R/C SENSOR S
Sets the remote control sensor to be used. This unit has its remote control sensor in two locations: at the front
and the rear.
Menu item
, PAL, PAL-M, PAL-N,
4.43
Menu item
AUTO/NTSC/NTSC
PAL60/SECAM
COMPONENT/RGB PC/RGB TV
COMPONENT/RGB PC/RGB TV
/ENGLISH/DEUTSCH/ESPAÑOL/
FRANÇAIS/ITALIANO/
OFF/ON
—
ALL SETTINGS/ALL MEMORIES/
CURRENT MEMORY
Choice/adjustment range
FRONT/TABLE, FRONT/CEILING,
REAR/TABLE, REAR/CEILING
4:3/16:9*
–96 to 96
–128 to 127
NORMAL/FULL
2Full correction
This correction adjusts the horizontal distortion without changing
the vertical length of the projected image.
When the upper part of the image is wider than the
lower part, increase the value to the positive (+)
direction.
When the lower part of the image is wider than the
upper part, decrease the value to the negative (–)
direction.
FRONT&REAR/FRONT/REAR
Menu structure
Choice
/PAL/PAL-M/PAL-N/
4.43
17
E-