Acutter Bar Assembly/Disassembly - LELY SPLENDIMO L Serie Betriebsanleitung

Supplement A
A CUTTER BAR ASSEMBLY/DISASSEMBLY
The figures placed between brackets correspond with the numerals in figure A-1.
The cutter bar is built up of independent units (1). These mower elements are kept apart by intermediate spacers (2). The
units and spacers are kept together by a connecting rod (3).
The cutting units are driven from the gearbox (4) by a drive shaft (5).
Thanks to the modular design, mower elements can be replaced quickly, as can the drive shaft.
12
11
4
10
13
6
1 2 5
3 9 8 7
A-1
Install supports underneath the cutter bar if it is lifted from the ground, and you intend to carry out work to the
machine.
Dismount the cutter bar as follows.
- Mount the machine in the tractor's 3-point hitch.
- Place the machine on a level floor.
- Remove the securing plate (6).
- Untighten the nut M30 (7) by a few turns.
- Remove the nut (7) and the ring (8).
- Remove the end plate (9) as well as the swathboard.
- Slide the mower elements and intermediate spacers from the connecting rod (3).
E-18