Mounting Behind The Tractor - LELY SPLENDIMO L Serie Betriebsanleitung

2 MOUNTING BEHIND THE TRACTOR

The 3-point headstock of the SPLENDIMO 165 and 205L mowers
matches a category I and II linkage (fig. 3).
- For category II: fit the filler bush on the outer linkage pin.
The headstock of the SPLENDIMO 205L HD , 240L, 280L and
320L mowers is fitted with adjustable linkage pins (category II) for
adjustment of the offset position of the machine behind the tractor
(fig. 4).
- Adjustment of the linkage pins should be so selected that the first
mowing disc is entirely offset from the track of the tractor tyre.
Lock the linkage pins by means of the securing bolts.
- Always use position
so that you can operate as far from the side as possible.
- Adjust the tractor 3-point hitch lower arms at equal height.
- Fit the lower arms to the linkage pins of the machine's headstock.
- Fit the tractor top link to the machine.
- Lift the headstock to such an extent that the hinge pin of the
intermediate chassis (fig. 5) is approx. 55 cm above ground level.
- Place the parking jack in the raised position.
- Secure the tractor lever arms by means of stabilisation chains or
rods keeping the mower from making sideward movements.
- Check if the PTO shaft telescopes smoothly.
- Mount the PTO shaft to the tractor PTO.
!
At first assembly or use of another tractor: check the minimum
and maximum overlap of the PTO halves
- Fit the safety chain of the protection tube to a rigid part of the
tractor.
- Connect the hydraulic hose to a single acting hydraulic tractor
valve with floating position.
Maximum allowed oil pressure: 21,0 MPa (210 bar).
- Place the end of the control cord for locking the ram in the tractor
cab.
- Check if the lever arms remain at an equal height when the cutter
bar is folded up.
*. Consult the instruction supplied with the PTO shaft
when mowing down a descending slope
*
.
165 L
205 L
205 L HD
240 L
280 L
320 L
55 cm
3
4
5
E-9