3. Installation for ATS
3.3
Front installation for rack mounting
Follow steps 1 to 3 for module mounting on the rails.
3.4
Rear installation for rack mounting
Follow steps 1 to 3 for module mounting on the rails.
3.5
Instructions
1. Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the operating ambient
2. Reduced Air Flow - Installation of the equipment in a rack should be such that the amount of air flow
3. Mechanical Loading - Mounting of the equipment in the rack should be such that a hazardous
4. Circuit Overloading - Consideration should be given to the connection of the equipment to the supply
5. Reliable Earthing - Reliable earthing of rack-mounted equipment should be maintained. Particular
Page 6
Downloaded from
www.Manualslib.com
temperature of the rack environment may be greater than room ambient. Therefore, consideration
should be given to installing the equipment in an environment compatible with the maximum ambient
temperature (Tma) specified by the manufacturer.
required for safe operation of the equipment is not compromised.
condition is not achieved due to uneven mechanical loading.
circuit and the effect that overloading of the circuits might have on overcurrent protection and supply
wiring. Appropriate consideration of equipment nameplate ratings should be used when addressing this
concern.
attention should be given to supply connections other than direct connections to the branch circuit (e.g.
use of power strips).
manuals search engine
ATS-01_EN