Eaton ATS 30 Installations- Und Bedienungsanleitung Seite 66

8. SNMP IPv6 for ATS
8.6
Command
Log
Tprev[1..9]
Event[1..9]
ClearLog
SetTime
SetDate
SetPrefer
SetDevID
SetVtp2s
SetVts2p
SetVbp2s
SetVbs2p
SetTdp2s
SetTds2p
SetMvs1
SetMvs2
SetMts1
SetMts2
Page 6
Downloaded from www.Manualslib.com
ATS Command Settings
Description
Report the event code and time of prior
transfers.
Report the time of prior transfer/event.
Tprev1 is the most recent time.
Report the event code for prior transfer.
Event1 is the most recent event.
Clear event log.
Set the present time.
Set the present date.
Set the preferred source.
Set the unit device ID.
Set the primary to secondary trip voltage.
Set the secondary to primary trip voltage.
Set the primary to secondary brownout
voltage.
Set the secondary to primary brownout
voltage.
Set the recover time of transfer from primary
to secondary.
Set the recover time of transfer from
secondary to primary.
Set the max voltage of comparing cycles for
primary AC blackout.
Set the max voltage of comparing cycles for
secondary AC blackout.
Set the max time of comparing cycles for
primary AC blackout.
Set the max time of comparing cycles for
secondary AC blackout.
manuals search engine
Parameter Response
1 ~ 10 hh:mm:ss MM/DD/YYYY
0x#
hh:mm:ss MM/DD/YYYY
0x#
hh:mm:ss
[MM/DD/YYYY]
MM/DD/YYYY
1 or 2
<20 characters>
alphanumeric
only
165.0 ~ 175.0
165.0 ~ 175.0
180.0 ~ 264.0
180.0 ~ 264.0
12.0 ~ 1800.0
12.0 ~ 1800.0
30 ~ 50
30 ~ 50
2.0 ~ 4.0
2.0 ~ 4.0
IPv6 for ATS-00_EN