Performing A Functional Test - Waeco MagicWatch MWE910 Montageanleitung

MagicWatch MWE910
Configuring the front sensors
You can set the travel speed at which the sensors switch off by connect-
ing the control electronics of the front sensors to the speedometer.
➤ Set parameter 11 to the required value.
You can set a switch-off time for the front sensors if you are unable to con-
nect the control electronics of the front sensors to the speedometer (e. g.
no speedometer signal or signal via CAN bus).
➤ Set parameter 12 to the required time.
You can set the system so that the front sensors not only display obsta-
cles intermittently but all the time until they are deactivated by the travel
speed or by switching off.
➤ Set parameter 16 to 1.
Suppressing the display of fixed objects (such as trailer hitches)
Supplementary to fig. j
➤ Insert a cable bridge (1) in the plug for the rear sensor control unit
between slots 4 and 16.
Restoring the factory settings
➤ Press both buttons for longer than two seconds.
✓ The display shows F5.
9

Performing a functional test

Supplementary to fig. k
Conduct the functional test of the rear sensors as follows:
➤ Switch on the ignition and shift into reverse gear.
Be very careful when you operate the device for the first time, and make sure
that you familiarize yourself with the various sequences of beeps.
Caution
a
In Zone 4, some obstacles may not be detected because they are
no longer within range of the sensors (construction-related charac-
teristic).
Performing a functional test
21