Troubleshooting; Possible Cause - Scheppach WSE1100 Original Bedienungsanleitung

16. Troubleshooting

The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool fails to
work properly. If the problem persists after working through the list, please contact your nearest service workshop.
Malfunction
The machine will not switch
on
No ignition spark
22 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

Possible cause

No mains voltage
The main fuse has tripped
On / off switch defective
Motor defective
Earth clamp not connected to the
device /
Earth clamp not fitted on the work-
piece
Remedy
Check the socket, mains cable, cable, mains
plug; have these repaired by a qualified electri-
cian if necessary.
Check the main fuse
Repair by customer service department
Repair by customer service department
Connect the earth clamp to the welding ma-
chine /
Fit the earth clamp on the workpiece