Working Procedures; Use; Switching On And Off; Emptying The Dust Collector - Parkside PBSD 600 A1 Bedienungsanleitung

Fitting the dust collector
♦ Push the dust collector
connection from above .
Dismantling/removing the dust collector
♦ Pull the dust collector
Connecting a dust extraction adapter and
reducer for an external extraction appliance
♦ Push the dust extraction adapter
connection .
♦ Push the reducer
adapter into the adapter fitting
♦ Push the hose from a suitable dust extraction
appliance (e .g . a workshop vacuum cleaner)
onto the reducer
extraction .
Removing the dust extraction adapter and
reducer for an external extraction appliance
♦ Pull off the hose of the dust extraction
appliance .
♦ Remove the reducer
extraction .
♦ Pull the dust extraction adapter
off the connection

Working procedures

A light grinding pressure is sufficient
■ Apply minimal pressure when grinding . The belt
grinder's own weight is sufficient for a good
grinding result . In addition, working this way
helps to reduce the wear on the abrasive belt
and the surface of the workpiece will become
more smooth .
Removal and surface
■ The material removal rate and surface quality
are determined by the belt speed and grain
strength of the abrasive belt
section "Selecting speed and abrasive belt") .
PBSD 600 A1
onto the dust collector
off upwards .
onto the
for the dust extraction
.
for external vacuum
for external dust
upwards
.
(see also the
Grinding
■ Place the appliance on the workpiece when
switched on and work at a moderate feed rate .
Guide the grinder in parallel and overlapping
sanding motions over the workpiece . To avoid
unpleasant transverse grinding marks, always
sand in the direction of the grain .
After completing the task, lift the appliance from
the workpiece and then switch it off .
NOTE
► Always hold the appliance firmly with two
hands while working .

Use

Switching on and off

While operating the belt grinder, you can choose
between instantaneous and continuous operation .
Switching to instantaneous operation
♦ Press the ON/OFF switch
Switching off instantaneous operation
♦ Release the ON/OFF switch
Switching to continuous operation
♦ Press the ON/OFF switch
and then press the lock button
Switching off continuous operation
♦ Press the ON/OFF switch
release it .

Emptying the dust collector

The dust collector should be emptied after every
10 minutes of operation at least .
♦ Pull the dust collector
"Attaching/removing a dust extraction unit")
♦ Shake the dust collector
bin to empty it .
♦ Fit the dust collector
appliance .
.
.
, keep it pressed in
.
and then
off (see section
over a rubbish
back onto the
GB │ IE │ NI │ CY │ 7 ■