Customer Service And Spare Parts; Troubleshooting - Schwamborn WDS 530 Originalbetriebsanleitung

EN Wall and ceiling grinding machine WDS 530 C
4 Maintenance

4.9 Customer service and spare parts

In case of customer service queries, replacement
parts or repairs, please contact the manufacturer of
the grinding machine. To ensure your queries are
dealt with as quickly as possible, always quote your
grinding machine data. These are located on the
grinding machine's type plate.

5 Troubleshooting

Only suitably knowledgeable, qualified
technicians may perform repairs on the grinding
machine.
Malfunction
Grinding machine will not
start.
The grinding drive stops du­
ring the grinding.
The grinding pattern is un­
even.
28
Cause
The guiding machine is not in opera­
tion.
The guiding machine is not in opera­
tion. An EMERGENCY STOP button
of the guiding machine has been
pressed.
The maximum hydraulic drive output
was exceeded. The safety valve has
switched off the grinding drive.
Extraction capacity is too high.
The vacuum causes excessive con­
tact pressure on the tools.
Tools are loose.
Tools are damaged or worn.
Tools are not suited for the material
of the surface.
The guiding machine is not parallel to
the wall or is not at the correct dist-
ance from the wall.
The grinding machine is positioned at
an angle to the wall.
Manufacturer: Schwamborn Gerätebau GmbH
Robert‐Bosch‐Straße 8
D‐73117 Wangen / Göppingen
Telephone: +49 (0)7161 2005‐0
Telefax: +49 (0)7161 2005‐15
E‐mail: info@schwamborn.com
URL: http://www.schwamborn.com
Rectification
Put the guiding machine into opera­
tion (! operating manual of the gui­
ding machine).
1. Determine the cause for the
emergency stop and rectify if ne­
cessary.
2. Release the EMERGENCY
STOP button afterwards
(! operating manual of the gui­
ding machine).
Use other grinding tools.
The manufacturer of the grinding
machine can gladly provide
corresponding recommendations.
Reduce the contact pressure.
(! Chapter 3.2, Pos. 6. ‐ page 24).
Reduce the extraction capacity.
Fasten grinding tools
(! Chapter 4.3 ‐ page 26).
Replace grinding tools
(! Chapter 4.3 ‐ page 26).
Use other grinding tools
(! Chapter 4.3 ‐ page 26).
The manufacturer of the grinding
machine can gladly provide
corresponding recommendations.
Position the guiding machine correctly
(! Fig. AC).
Position the grinding machine cor­
rectly (! Chapter 3.1 , page 22).