Operating; Putting The Grinding Machine Into Operation - Schwamborn WDS 530 Originalbetriebsanleitung

EN Wall and ceiling grinding machine WDS 530 C

3 Operating

Risk of injury from rotating grinding machine
parts!
Limbs and clothing can be drawn in!
Proceed with the greatest care and caution!
Any work required for the hydraulic system may
only be performed by technicians with the
requisite levels of qualification.
Risk of poisoning due to harmful substances at
the workplace!
Eating, drinking or smoking at the workplace is
prohibited! Always eat in break rooms or can­
teen areas!
After completing the work, thoroughly clean
yourself!
A general inspection of the machine must be
conducted before starting up the grinding
machine! Particular attention should be paid to
damaged or loose components, and wear!
The grinding machine may only be put into
operation if it is in perfect technical condition!
Adding to or modifying the grinding machine in
any way that could compromise operating safety
is prohibited!
Cleaning and maintenance may be done only by
trained personnel!
Maintenance must be conducted according to
the operation manual.
Do not operate the grinding machine in areas
where there is risk of explosion or where
flammable materials are present.
3 Operating
22
Risk of injury from parts flung out during
grinding!
Wear protective clothing and protective goggles!
Wear safety shoes!
Wear protective gloves!
Proceed with the greatest care and caution!
Danger of injury from loud noise during grinding
operation of the grinding machine!
Always wear hearing protection when the
grinding machine is in operation!
Risk of injury from dust formation during grind­
ing work!
Wear respiratory protection!
A suitable extractor unit has to be connected to
the grinding machine.
Risk of damage due to excessive extraction ca­
pacity!
The manufacturer strongly recommends only
using Schwamborn extractors.
3.1 Putting the grinding machine into
operation
Observe the safety instructions in Chapter 2!
The initial start‐up of the grinding machine may
be carried out only by qualified personnel!
A visual inspection of the grinding machine
needs to be done before starting up the grinding
machine.
Particular attention should be paid to damaged
or loose components, and wear!
Always use suitable grinding tools or abrasive
bonding for the surface to be machined. The
manufacturer of the grinding machine can gladly
provide corresponding recommendations.
6. Check the surface to be ground and remove any
protruding objects.
7. Turn the grinding machine in the direction of the
guide arm (! Fig. B) and place with the sup­
porting feet [11, Fig. B] on a level, horizontal
floor with adequate load capacity (e.g. pallet or
floor) (! Chapter 6.2 page 29).