Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Configuration
Changing the video mode of consoles
In the standard configuration of the KVM extender, the computer's image is output at
the monitor of the active console as well as at the monitor of the concurrent console.
You can also specify that the image of the other console is temporarily or permanently
switched off as soon as an entry is made at a console.
How to select the video mode of a console:
1. Press
Ctrl+Num
2. Select the row
mode for the remote console (at the
Select the row
video mode for the local console (at the
3. Under
Video mode
always on
switch off
keep off
4. Press
to save your settings.
F2
41 · G&D DP-Vision-IP-Fiber
(default) to open the on-screen display.
Console setup
and press
Local console setup
and press
press
to select one of the following options:
F8
The computer screen is displayed on both the
monitor of the active and the monitor of the
concurrent console (default).
The screen of this console (depending on the selection
made in step 2) is temporarily switched off whenever an
entry is made on the concurrent console.
After the time period of the input lock (see below) has
elapsed, the screen is automatically switched on again.
The screen of this console (depending on the selection
made in step 2) is switched off permanently if an entry is
made on the concurrent console.
After the time period of the input lock (see below) has
elapsed, you need to make an entry on this console to
switch on the screen again.
Enter
if you want to adjust the video
CON
module).
Enter
if you want to adjust the
CPU
module).
Werbung
Kapitel
Inhaltsverzeichnis
