Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Establishing a KVM-over-IP™ connection for the first time
Configuring a KVM-over-IP connection of a user
module
You can carry out the required configuration settings directly on the console.
NOTE:
Use the
local hotkey
the network interface of the user module, or use the
Ctrl
+
Num
) to open the remote OSD to configure the network interface of the com-
puter module.
The settings of both hotkeys are shown during the starting process of the user
module (see Starting process on page 14).
Configuring the network interface
How to configure the network interface:
1. Use the remote hotkey
2. Select the entry
3. Select the entry
4. Enter the following data under
Operational
mode:
IP address:
Netmask:
5. Press
F2
to save your settings.
Configuring the global network settings
Even in complex networks global network settings ensure that the KVM extender is
available from all partial networks.
How to configure global network settings:
1. Use the remote hotkey
2. Select the entry
3. Select the entry
19 · G&D DP-Vision-IP-Fiber
(default:
Alt
+
Num
to open the OSD of user module.
Network setup
and press
Interfaces
and press
Interface A
Press
F8
to select the operational mode of the interface:
Static:
A static IP address is assigned.
IP address is obtained from a DHCP server.
DHCP:
Enter the IP address of the interface.
The operational mode DHCP does not allow making entries.
Enter the netmask of the network.
The operational mode DHCP does not allow making entries.
+
to open the OSD of the user module.
Alt
Num
and press
Network setup
and press
Interfaces
Alt
+
Num
) to open the local OSD to configure
Enter
.
Enter
.
:
.
Enter
.
Enter
remote hotkey
(default:
Werbung
Kapitel
Inhaltsverzeichnis
