G&D DP-Vision-IP-Fiber-Serie Installation Und Bedienung Seite 121

How to set the operating mode of the RS232 interface:
1. Press Ctrl+Num
2. Select the row
operating mode of the RS232 interface of the console module (
Select the row
operating mode of the RS232 interface of the computer module (
3. Under RS232 port mode
RS232  The data stream of an RS232 device is transmitted from the
computer module to the console module (default setting).
RS422  The data stream of an RS422 device is transmitted from the
computer module to the console module via separately
available
4. Press to save your settings.
F2
1. In the menu, click on
2. Click on the computer module (CPU) you want to configure and then
click on Configuration
3. Click on the tab
4. Click on the tab
RS232 interface of the computer module.
Click on the tab
RS232 interface of the console module.
5. Select one of the options of the
graph Configuration
RS232  The data stream of an RS232 device is transmitted from the
computer module to the console module (default setting).
RS422  The data stream of an RS422 device is transmitted from the
computer module to the console module via separately
available
6. Click on
Save
(default) to open the on-screen display.
and press
Console setup
Target setup and press
press F8 to select on of the following options:
G&D RS232-422 adapters
.
KVM extender
.
.
General
if you want to adjust the operating mode of the
CPU
if you want to adjust the operating mode of the
CON
Serial communication
:
G&D RS232-422 adapters
.
if you want to adjust the
Enter
Enter if you want to adjust the
.
field under the para-
.
G&D DP-Vision-IP-Fiber · 40
Configuration
CON ).
CPU ).