Klarstein Steakreaktor Core Handbuch Seite 27

Now you have the following two options:
A) Grilling with preset temperature and time values
1. Press the controller (2) to start the grilling process with the preset values. A signal
tone sounds.
2. The grill now heats up and the display (1, 3) shows the temperature and remaining
time.
NOTE: The heating process can be interrupted at any time. To do this, hold the controller
(2) down for approx. 2 seconds. To restart the heating process, press the controller (2)
and proceed again as described above.
3. From a temperature of approx. 100 °C, the fans (4) on the back of the grill are
switched on to cool the housing.
4. When the set target temperature is reached, a signal tone sounds and the grill is
ready for use.
B) Changing the temperature and time values
1. First select the desired grilling temperature between 800 °C and 200 °C by turning
the controller (2). During the setting process, "C" flashes in the display (1). Confirm
your selection by pressing the controller (2). A signal tone sounds.
2. Now select the desired running time between 1:00 and 30:00 minutes by turning
the controller (2). During the setting process „:" flashes in the display (3). Confirm
your selection by turning the controller (2). A signal tone sounds.
3. The grill now heats up and the display (1, 3) shows the temperature and remaining
time.
NOTE: The heating process can be interrupted at any time. To do this, hold the controller
(2) down for approx. 2 seconds. To restart the heating process, press the controller (2)
and proceed again as described above.
4. From a temperature of approx. 100 °C, the fans (4) on the back of the grill are
switched on to cool the housing.
5. When the set target temperature is reached, a signal tone sounds and the grill is
ready for use.
Note: The current temperature shown in the display (1) is measured by a temperature
sensor built into the heating element (6). The actual temperature on the grill rack (1 1)
may differ from this.
EN
27