Panasonic ES‑LV81 Handbuch Seite 11

Follow the steps outlined below if the status

lamp blinks or glows
Blinks
Correctly set the
detergent cartridge and
then restart a course.
If the status lamp goes
out
Continue a course.
When an abnormality
has been corrected
Remove the AC adaptor
from a household outlet.
When the status lamp
goes out
Continue a course.
ES-LV81_EU.indb 11
Glows
Remove the shaver from the
self‑cleaning recharger and
then check that the [CLEAN]
lamp has gone out. (Be careful
as the blade may be hot or
wet.) Check that the water tank
is correctly attached, the water
tank cap is securely closed and
the self‑cleaning recharger is
placed horizontally.
When no abnormality was
found
It is time to replace the
detergent cartridge and
cleaning liquid inside the
water tank. Wash away the
old cleaning liquid and then
rinse the water tank and then
refill it with water. Replace
the old detergent cartridge
and then restart the course.
When the status lamp
glows again
Contact an authorized
service center.
Cleaning the shaver without the self‑cleaning
recharger
We recommend that you clean your shaver with the self‑
cleaning recharger or the sonic vibration cleaning mode when
the faucet symbol appears on the LCD panel.
1. Disconnect the power cord from the
shaver.
. Apply some hand soap and some water
to the outer foil.
. Rotate the lock ring [D7] to unlock the
power switch [D8].
. Press the power switch [D8] for more
than  seconds to activate the sonic
vibration cleaning mode.
•
appears on the LCD panel.
•
After about 0 seconds, it will be
automatically turned off, or you can
turn it off by pressing the power switch.
5. Remove the outer foil section [B] and
press the power switch [D8] for more
than  seconds to activate the sonic
vibration cleaning mode and clean it with
running water.
. Wipe off any drops of water with a dry
cloth.
7. Dry the outer foil section [B] and the
shaver completely.
8. Attach the outer foil section [B] to the
shaver.
9. Lubricate the shaver.
4
5
7
11
2011/02/16 14:34:04