Panasonic ES‑LV81 Handbuch Seite 10

Cleaning the shaver

Use the self‑cleaning recharger in temperatures between
15 °C and 5 °C.
1
1
Insert the appliance plug [E=]
into the self‑cleaning recharger
[F].
2
2
Remove the protective cap [A]
and then attach the shaver.
3
3
Plug in the AC adaptor [E] into
a household outlet.
•
Remove any soap or water on the shaver if it has been
washed with hand soap or any other detergent.
•
Turn the shaver off before attaching.
•
Check that the outer foil is not deformed or damaged when
you are attaching the shaver.
•
Wipe off any water droplets on the main body rear terminal.
4
4
Press the SELECT button [F] to select the
course.
•
The "Charge" course starts when attaching the shaver.
•
Each time you press the SELECT button, the course
changes from "Clean/Dry/Charge"
"Charge".
•
The courses start approximately  seconds after they are
selected.
•
The course will be aborted if the power is cut off. In this case,
perform the course again from the beginning.
•
Do not detach the detergent cartridge or the water tank as
the cleaning liquid may spill causing a malfunction.
10
ES-LV81_EU.indb 10
1 Charge
2 Clean/Dry/
3
2
Charge
1
3 Dry/
Charge
"Dry/Charge"
* When the ambient temperature of the self‑cleaning recharger
is low (approx. 15 °C or lower), the time it takes to dry the
shaver increases.
•
The Clean or Dry function may stop under extreme low
temperatures (approx. 0 °C or lower). In such a case, the
CLEAN and DRY lamps will blink when the "Clean/Dry/
Charge" course is selected, or the DRY lamp will blink when
the "Dry/Charge" course is selected.
Course Time required (guide)
Charge
0 to 0 min
Clean
10 min
(170 min*)
•
It is not possible to change the course after
the "Clean/Dry/Charge" course has started.
Dry
180 min 0 to 0 min
•
It is possible to change to the "Clean/Dry/
Charge" course even after the "Dry/Charge"
course has started.
Dry
Charge
80 min
0 to 0 min
Charge
2011/02/16 14:34:04