Manual Cleaning - Silvercrest SHBR 560 A1 Bedienungsanleitung

Manual cleaning

For heavier soiling, it is necessary to manually clean the rotary brush
splash guard
If this occurs, do the following:
Make sure that the appliance is not plugged in.
Take hold of the top of the splash guard
and pull it forward to remove it from the foot section
Take hold of the bracket on the left side of the rotary brush
upwards to remove the rotary brush from the foot section
Fig. 33
Clean the splash guard
fig. 35).
If the brush chamber is dirty, wipe it out with a damp cloth or rag (see fig. 36).
Fig. 35
Allow the rotary brush
fitting them back onto the appliance (see fig. 37).
You can also place the rotary brush
the parking and cleaning station for drying (see Figure 38).
■ 96 │ GB │ MT
7
and the brush chamber in the foot section
7
and the rotary brush
6
and the splash guard
7
by the edge of the handle (
3
(see fig. 33).
3
Fig. 34
6
in hot running water (see
Fig. 36
7
to dry completely before
6
upright in the rotary brush holder
6
, the
3
of the appliance.
)
6
and pull it
(see fig. 34).
5
on
SHBR 560 A1