Silvercrest SHBR 560 A1 Bedienungsanleitung Seite 104

Fault Cause
The fresh water
tank
The fresh water
tank
properly.
The appliance
The appliance is not
does not
completely ready for
dispensing
use.
enough clean-
ing solution.
The cleaning solution
switch
being pressed down
continuously.
The splash guard
is not fitted properly.
The rotary brush
not fitted properly.
The rotary
6
brush is not
turning.
The rotary brush
blocked.
Water is leak- The fresh water
ing from the tank
appliance. properly.
SHBR 560 A1
Remedy
Fill up the fresh water tank
q
is empty.
Filling the fresh water tank).
Take the fresh water tank
q
is not closed appliance and tighten the lid (see section
Filling the fresh water tank).
Before each use, press and hold the cleaning
solution switch
add cleaning solution to the rotary brush
so that it is ready for use.
Press and hold the cleaning solution switch
t
is not
the rotary brush
7
Fit the splash guard
Manual cleaning).
Switch the appliance off and pull out the mains
6
is plug.
Fit the rotary brush
section
Remove the plug from the mains power socket.
Remove the splash guard
brush
6
Fit the rotary brush
is
back onto the appliance (see section Manual
cleaning).
Insert the plug into a mains power socket and
switch on the appliance.
Take the fresh water tank
q
is not closed
appliance and tighten the lid (see section
Filling the fresh water tank).
t
for about 10 seconds to
t
to continuously apply cleaning solution to
6
.
7
properly (see section
6
properly onto the foot
3
(see section Manual cleaning).
6
to clear the blockage.
6
and the splash guard
q
(see section
q
out of the
6
7
and the rotary
7
q
out of the
GB │ MT │
101 ■