Mounting And Dismantling Surface Mills; Cleaning The Machine; Checking Electrical Components; Final Tasks - Schwamborn DSM 530S Originalbetriebsanleitung

5 Acceptance and transportation

EN Floor grinding machine DSM 530S / DSM 650S / DSM 800S
2. Gently tap with a lump hammer to loosen the
tools [32, Fig. J] from the EXT locating
plate [29, Fig. J] and then remove.
3. Insert new tools into the gap [31, Fig. J] of the
ETX locating plate and press firmly in the direc-
tion of the arrow (use lump hammer if neces-
sary).
4. Set the machine upright (

4.4 Mounting and dismantling surface mills

All locating plates need to be equipped with
complete surface mills of the same type. En-
sure that there is an equal degree of wear on
all surface mill elements [34, Fig. K] .
1. Tilt the machine (
2. Using the supplied screws (3 each, M8), fasten the
three surface mills [35, Fig. K] to the ETX locating
plates.
3. Set the machine upright (
If surface mills are being used, the speed
(SPEED) should not be set to more than
max. 50%( Chapter 3.3).

4.5 Cleaning the machine

1. Tilt the machine (
2. After using the machine and tools, clean and dry
them with a cloth or suitable agents.
3. Set the machine upright (

4.6 Checking electrical components

Only suitably knowledgeable, qualified pro-
fessional electricians may perform work on
any electrical components of the machine.
Risk of fire due to faulty electrical cables!
Check the power line and power plug regu-
larly for functional safety.

4.7 Final tasks

Either decommission the machine
a. Disconnect the power plug [4, Fig. A] from
the mains.
Reduce the projection if necessary:
20
Chapter 4.2).
Chapter 4.2).
Chapter 4.2).
Chapter 4.2).
Chapter 4.2).
b. Securely grip the guide bar [3, Fig. A] or
secure it against falling and turn the clam-
ping nuts [21, Fig. E] anticlockwise until the
locking disks [22, Fig. E] are no longer en-
gaged.
c. Adjust the guide bar to the forward position
(above the drive motor, Fig. L) and tighten
the clamping nuts clockwise so that the
locking disks engage.
or
— Restart the machine
( Chapter 3.1 – page 17).
5 Acceptance and transportation
Follow the safety instructions in Chapter 2.

5.1 Machine acceptance

The packaged machine is supplied complete from the
manufacturer.
1. Unpack machine and check the delivery slip to
make sure all parts are delivered.
2. Check for any transportation damage.
In case of damage, contact the transport com-
pany promptly.
Report any problems to the manufacturer imme-
diately.
Complaints at a later date cannot be acknowled-
ged!

5.2 Transporting the machine

Risk of injury from heavy parts!
Suspended loads can fall or tip over, cau-
sing serious injuries!
Do not stand under suspended loads!
Raising and lowering the load must be per-