Installation And Connection; Installation Guidelines; Preparing For Installation - Balluff BTL7-V50E-M A-C003 Serie Betriebsanleitung

BTL7-V50E-M _ _ _ _ -A/B/Y/Z(8)-C003
Magnetostrictive Linear Position Sensor – Rod Style
4

Installation and connection

4.1

Installation guidelines

Non-magnetizable material
Non-magnetizable material
Magnet
1) Min. Ø D2 = Minimum diameter of the bore (see Tab. 4-1)
Fig. 4-1: Installation in non-magnetizable material
Magnetizable material
If using magnetizable material, the BTL must be protected
against magnetic interference through suitable measures
(e.g. spacer ring made of non-magnetizable material, a
suitable distance from strong external magnetic fields).
15
8
Magnet Spacer ring made of non-magnetizable
material
15
8
Magnet Spacer ring made of non-magnetizable
material
Min. Ø D2 = Minimum diameter of the hole (see Tab. 4-1)
1)
Fig. 4-2: Installation in magnetizable material
Rod diameter
10.2 mm
8 mm
Tab. 4-1: Bore diameter if installed in a hydraulic cylinder
10 english
Bore diameter D2
At least 13 mm
At least 11 mm
4.2

Preparing for installation

Installation note: We recommend using non-
magnetizable material to mount the BTL and magnet.
Horizontal assembly: For horizontal assembly with
nominal lengths > 500 mm, support the rod and tighten it
at the end if necessary (only possible with a diameter of
10.2 mm).
Hydraulic cylinder: If installed in a hydraulic cylinder,
ensure that the minimum value for the bore diameter of the
support piston is complied with (see Tab. 4-1).
Mounting hole: The BTL comes with an M18×1.5 (ISO) or
3/4"-16UNF (SAE) mounting thread. Depending on the
version, a mounting hole must be made before assembly.
Fig. 4-3: Mounting hole M18x1.5 per ISO 6149 O-ring 15.4x2.1
Fig. 4-4: Mounting hole 3/4"-16UNF per SAE J475 O-ring 15.3x2.4
Magnet: Various magnets are available for the BTL (see
Accessories on page 15).