Herunterladen Inhalt Inhalt Diese Seite drucken

Setting Ethernet Port Of Charger To Static Ip In Standalone Usage Mode - VESTEL EVC04 Seriel Installationsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

2.11 - SETTING ETHERNET PORT OF CHARGER TO STATIC IP IN STANDALONE
USAGE MODE
If you need to set the Ethernet port of your charger to static IP, below steps should be followed:
Make sure the charging station is powered-off and open the front cover of your charger which is mentioned
in installation guideline.
Toggle the second position of dip switch which is on the smart card of the charger shown in figure 29. After
that please turn on the charger again.
Charging station sets the Ethernet port to 192.168.0.10 adress statically and subnet mask will be set to
255.255.255.0
If the charger's Ethernet port is needed to be set in DHCP mode, this should be done from the webconfig interface.
2.12 - WEBCONFIG UI ENABLE / DISABLE
If you need to enable/disable the WebConfig UI below steps should be followed:
Make sure the charging station is powered-off and open the front cover of your charger which is mentioned
in installation guideline.
If you want to enable the WebConfig UI, third position of dipswitch should be in "OFF" position as shown
in figure 30.
If you want to disable the WebConfig UI, third position of dipswitch should be in "ON" position as shown
in figure 30.
IG v7.3.0 2020
Toggle
Figure.29
Toggle
Figure.30
© 2020 Vestel - All rights reserved
ON
1
2
3
4
5
6
ON
1
2
3
4
5
6
English - 31

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis