Product Installation Steps; Opening The Cover Of The Charging Station - VESTEL EVC04 Seriel Installationsanleitung

2 - PRODUCT INSTALLATION STEPS

CAUTION!
Ensure that ground resistance of the installation less than 100ohms
Prior to mounting your charging station on the wall, read these instructions.
Do not mount your charging station to the ceiling or an inclined wall.
Use the wall mounting screws and other accessories specified.
This charging station is classified as indoor and outdoor installation compatible. If the device
is installed outside the building, the hardware that will be used to connect the cables to the
charger shall be compatible with outdoor use and the charging station shall be mounted
preserving the IP rate of the charger.

2.1 OPENING THE COVER OF THE CHARGING STATION

1-
Right Angle Screwdriver Adapter using Torx T20 Security Bit.
2-
IG v7.3.0 2020
Please power off the charging station mains supply
1
Remove the cover screws with Torx T20 security L-Wrench or
Open the cover.
© 2020 Vestel - All rights reserved
Figure-8
2
English - 14