VESTEL EVC04 Seriel Installationsanleitung Seite 86

You can set OCPP configuration parameters to their default values by clicking "Set to Defaults"
button.
You can select the OCPP settings type you want from the menu which is at the left side of the page.
For example OCPP Connection,OCPP Version,Connection Settings and OCPP
Configuration Parameters.
Then, click "Save" button.
Please be careful for your entered values because the system does not accept the unsuitable values
and gives the warning. In this case, values will not be saved. Then the
page does not to be redirected the main page so you should check your values.
Also if you make changes and you don't save them before the leaving that page, you will see the
warning as shown below.
IG v7.3.0 2020
Figure.38
Figure.39
© 2020 Vestel - All rights reserved English - 38