VESTEL EVC04 Seriel Installationsanleitung Seite 78

2.9 - OPEN RCD COVER
1
You may access the residual current device by openin the lock which is placed on the side cover
as shown in the figure 27. Place and push triangle key on the side cover lock then rotate the key
90 degree counter-clockwise.
2.10 - RESETTING LOCAL RFID CARD LIST AND REGISTERING NEW MASTER
RFID CARD IN STANDALONE USAGE MODE
If you loose your master RFID card and need to define a new master RFID card, below steps
should be followed by your authorised service technician.
Make sure the charging station is powered-off and open the front cover of your charger
which is mentioned in installation guideline.
Toggle the first position of dip switch which is on the smart card of the charger shown in
figure 28. After that please turn on the charger again.
When the charger re-energised, please note that;
Previously stored master card and user card list, if any exists, are deleted from charging
station while entering the configuration mode.
If master card had not been registered during 60 seconds then configuration mode expires
and charging station behaves as autostart product.
The first RFID card which is registered within this 60 seconds of duration will be the new
master RFID card. Please follow instructions to register RFID user card which is used
during charging process.
IG v7.3.0 2020
2
Figure-27
Figure.28
© 2020 Vestel - All rights reserved
3
ON
ON
1 2 3 4 5 6
OFF
English - 30