VESTEL EVC04 Seriel Installationsanleitung Seite 80

3 - OCCP CONNECTION (Optional)
Make sure the charging station is powered-off.
3.1 - CONNECT OCPP OVER CELLULAR NETWORK
Insert the Micro SIM card in the cellular module SIM card slot as shown in the below figure.
3.2 - CONNECT OCPP OVER ETHERNET
1- Insert cable through the cable gland. See
section "2.6.1 Data Cable Connection"
instructions, 1 and 2.
3- Using a Crimping Tool, trim the end of the
cable you're terminating, to ensure that the
ends of the conducting wires are even.
IG v7.3.0 2020
Figure-31
2- Pull the cable through the cable clamps as
indicated by arrows in below figure.
4- Strip off approximately 1 inch of the cable's
jacket, using a modular crimping tool or a
UTP cable stripper.
© 2020 Vestel - All rights reserved
CN1
English - 32