Pelgrim IDK650 Anleitung Seite 65

installation
128
Ventilationprotection
The electronics in the appliance require cooling. The cool air is sucked from
behind the cupboard and blown out at the front and at the bottom in the front
of the appliance. The hob can only operate if there is sufficient circulation of
fresh air.
The appliance will switch off after a short time if there is not enough circulation.
See to it that the traverse lath does not hinder the airflow. Plane or saw the lath
oblique if necessary.
Above a 60 cm oven of the Pelgrim brand
Recess height minimum 600 mm.
Ventilation is via plinth and rear of
oven. Where there is a oven, a gap of
at least 560 x 6 mm should be made at
the front. Cut out ventilation openings
"A" + "B" (100 cm
in the side wall "C" of the kitchen
cupboard for leading the connection
cable through.
The hob may only be combined with Pelgrim ovens, not with combi-microwave
ovens.
Ensure that the connection cables hang freely. If there is a drawer underneath
the hob, make sure that the contents do not project above the edge of the
drawer and interfere with the ventilation.
B
2 ). Make an opening
129
C
600
A
installation
Installation of the induction hob above a combimicrowave oven, a 90 cm
Pelgrim oven or an oven of a different brand
Saw out the ventilation opening(s),
making sure that the total surface of
the holes is a minimum of 100 cm 2 . See
the drawing, for example, showing
2 holes.
Fit a protective plate between the oven
and the hob. The plate should be at
least 10 mm thick and heat-resistant
(85 °C). The space between the
underside of the hob and the
protective plate must be at least
50 mm.
To protect the air flow, fit a protective
panel - of the same material as the
protective plate - between the
protective plate and the hob.
Ventilation is via the adjoining
cupboards.
Install the appliance in such a way that the power plug remains accessible
always.
2
50 cm
e
t
e
r
t
e r
min.
560 x 6 mm
48
50