WMF 5 Bedienungsanleitung Seite 42

Inserting the water
filter (see Fig. 7)
change indicator
Assemble the suction cap
Fill and insert the
10
Downloaded from www.Manualslib.com
Start-up
>
Depending on the quality of your tap water, you may need to replace the water filter
point
The water filter ensures that the coffee is pure in taste. It filters chlorine and other impurities
from the water.
>
First of all, rinse the water filter under the tap.
>
Insert the water filter
in.
Set the
The water filter loses effectiveness the more it is used. With an average daily use of 8 cups of coffee, the
(see Fig. 1)
water filter will need to be replaced after 2 months at the latest (around 500 cups).
>
Set the replace indicator
replacement is due.
Water filters can be purchased from stockists.
Even if you do not want to use a water filter, the suction cap
(see Fig. 7) the tank may not be emptied fully when preparing the beverage and the last cup will not be filled
completely.
>
Take the suction cap
Make sure that the arrow marking on the suction cap points towards the water tank handle.
>
Fill the water tank with cold tap water up to the maximum mark.
>
water tank Place the tank cover back into the water tank.
>
Place the water tank into the appliance.
The ready indicator
manuals search engine
P Q
into the holder ring on the floor of the water tank without pressing it
A
above, next to the tank, to the time when the next water filter
O
and insert it firmly into the holder ring on the floor of the water tank.
F
flashes white when requiring a rinse.
P
at this
O
must be assembled correctly. Otherwise,