Operation - EuroLite CRT-200PRO Bedienungsanleitung

OPERATION

(1) Switch on the control unit with the power switch and insert the supplied SD card into the card slot.
The control unit will not operate properly without memory card.
(2) Select the desired operating mode with the button MODE. The operating mode is shown in the display.
CH00 – CH23: Automatic program run
(1) Press the button MODE so many times until (CHXX) is indicated in the display. Use the buttons UP and
DOWN to select one of the programs stored on the SD card:
CH00 continuous change of all programs
CH01 program1
CH02 program2
CH23 program23
(2) The SENS control allows to adjust the speed of the program in this operating mode.
Jr: red LEDs
Press the button MODE so many times until Jr is indicated in the display. Only the red LEDs will light.
Jg: green LEDs
Press the button MODE so many times until Jg is indicated in the display. Only the green LEDs will light.
Jb: blue LEDs
Press the button MODE so many times until Jb is indicated in the display. Only the blue LEDs will light.
So1D: Sound control
(1) With music played at sufficient volume, the LEDs, controlled via the microphone, will light alternately to
the beat of the music. To select sound control press the button MODE until SoQD is indicated in the
display:
(2) The SENS control allows to adjust the microphone sensitivity in this operating mode.
3001-3512: DMX-controlled operation
To be able to operate the curtain with a DMX controller, the DMX starting address must be set for the first
DMX channel. For this press the button MENU so many times until RXXX is indicated in the display. Then
use the buttons UP and DOWN to set the address.
DMX channel Function
CH-1 Blackout
CH-1 Program selection
CH-2 Speed
DMX value
0~9
10~255
0~255 (slow fast)
18/20 00068713.DOC, Version 1.2