General; Identification Of Model Version; Normal Use; Improper Use - WALTHER PILOT WA 800 Betriebsanleitung

1

General

1.1

Identification of Model Version

Models: Automatic Spray Gun PILOT WA 800-Serie
Types:
WA 800
WA 805
WA 810-U
WA 815-U
WA 820-HVLP
WA 825-HVLP
WA 830-HVLP-U
WA 835-HVLP-U
WA 840-MP
WA 845-MP
WA 850-MP-U
WA 855-MP-U
WA 870-K
WA 871-K-U
WA 872-HVLP-K
WA 873-HVLP-K-U (Low pressure-adhesive version-circulation) V 20 873
Manufacturer: WALTHER Spritz- und Lackiersysteme GmbH
Kärntner Str. 18-30
D-42327 Wuppertal
Tel.: 0202 / 787-0
Fax: 0202 / 787-2217
www.walther-pilot.de • Email: info@walther-pilot.de
1.2

Normal Use

The automatic spray guns PILOT WA 800, WA 805, WA 810, WA 815, WA 820, WA
825, WA 830, WA 835, WA 840, WA 845, WA 850, WA 855, WA 870, WA 871, WA 872
and WA 873 are exclusively designed for use with sprayable material types and gra-
des. All material conduction parts are made of stainless steel so as to permit handling
of hydrous media such as:
• paints and lacquers
• greases, oils and corrosion preventives
• adhesive compounds
• ceramic glazes and
• pickling solutions
Should the materials which you want to spray not be listed above, please contact us
for further and detailed information.
Plase note that sprayable material may only be applied to work pieces and/or similar
items.
The temperature of the spraying materials shall never exceed 80 degrees Celsius.
Downloaded from www.Manualslib.com
(Standard with internal control)
(Standard without internal control)
(circulation with internal control)
(circulation without internal c.)
(Low pressure with internal control)
(Low pressure without internal control)
(Low pres.-circulation with internal c.)
(Low pres.-circulation without internal c.) V 20 835
(Mediem pressure with internal control)
(Medium pressure without internal c.)
(Medium pres.-circulation with internal c.) V 20 850
(Medium pres.-circulat. without internal c.)
(Adhesive version)
(Adhesive version-circulation)
(Low pressure-adhesive version)
34
manuals search engine
The models PILOT WA 800 and the corresponding versions of adhesive coating
PILOT WA 870-K - WA 873-HVLP-K-U are not designed for manual operation, and
must be installed in a suitable gun mounting device.
The term normal use also implies that any and all safety warnings, operational hand-
ling details, etc., as stated in these operating instructions, must be carefully read,
V 20 800
understood and duly complied with.
V 20 805
V 20 810
V 20 815 This equipment complies with the explosion protection requirements of Directive
V 20 820 2014/34/EU (ATEX) for the explosion group, equipment category and temperature
V 20 825
class indicated on the type plate. When using the equipment, the requirements spe-
V 20 830
cified in these Operating Instructions must be observed at all times.
V 20 840
The technical data indicated on the equipment rating plates and the specifications in
V 20 845
the chapter "Technical Data" must be complied with at all times and must not be
exceeded. An overloading of the equipment must be ruled out.
V 20 855
The equipment may be used in potentially explosive atmospheres only with the autho-
V 20 870
risation of the relevant supervisory authority.
V 20 871
V 20 872
The relevant supervisory authority or the operator of the equipment are respon-
sible for determining the explosion hazard (zone classification).
The operator must check and ensure that all technical data and the marking of the
equipment in accordance with ATEX are compliant with the necessary requirements.
The operator must provide corresponding safety measures for all applications in
which the breakdown of the equipment might lead to danger to persons.
If any irregularities are observed while the equipment is in operation, the equipment
must be put out of operation immediately and WALTHER Spritz- und Lackiersysteme
must be consulted.
Grounding / Equipotential Bonding
You must ensure that the spray gun is properly earthed (grounded) either separately
or in connection with the equipment with which it is being used (maximum resistance
10 Ω).
6
1.3
This spray gun shall not be used for purposes other than set forth in the above
Chapter 1.2 Normal Use. Any other form of use and/or application is prohibited.
Improper use is for example:
• spraying of material onto persons and animals
• spraying of liquid nitrogen, etc.

Improper Use

35