Hardware Configuration Dialog - Siemens CP 1401 Installationsanleitung

S79220-A0707-A-02-7419
6.4.3

Hardware Configuration Dialog

Description
IRQ Interrupt
Number
IF you have selected one of the following
combinations,
Interface Module
Interrupt
IRQa
IRQb
IRQc
Note
In this dialog, you select the parameters set during the
hardware installation (see Section 5).
Here, only one interrupt number must be entered, as a
reminder: in the BIOS Setup, two interrupts were selected
(the interface module and the PC interrupt).
Since only one interrupt number must be entered, the system
assumes default combinations of the interface module and
PC interrupt.
The following table shows which interrupt number to enter for
which combination:
PC Interrupt
3
4
5
If the interrupt combination you have entered in the
BIOS Setup is not one of the default combinations
described above, follow the steps explained in the
next section.
71
SIMATIC NET CP 1401
THEN enter the following interrupt
number in the "Hardware
Configuration" dialog:
3
4
5
© Copyright by SIEMENS AG