Changing, Deleting The Cp Configuration - Siemens CP 1401 Installationsanleitung

SIMATIC NET CP 1401
6.5.2

Changing, Deleting the CP Configuration

Edit Functions
Change CP
Configuration
Remove CP
© Copyright by SIEMENS AG
Using the "Edit" menu of SINEC Setup, the following
functions are available after you select a CP 1401, CP 1411,
CP 1511 or "OTHER":
Change CP configuration
Remove CP
Select the CP 1401 module. Any changes you make
with this menu only become effective after you have
booted your computer.
The "Change CP Configuration" function allows you to
change the configuration parameters of the CP 1401.
The configuration program displays the same user interface
as the installation program for SOFTNET H1.
If SINEC Setup indicates that the CP is not yet
configured, you cannot change the configuration.
You must then use the installation program.
With the "Remove CP" function, you delete the files specific
to the CP 1401 on the hard disk. The entries made by the
installation program are canceled.
80
S79220-A0707-A-02-7419