Service Information; Disposal And Recycling; Troubleshooting; Possible Cause - Scheppach HC24V Original Bedienungsanleitung

10.7 Service information

Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Belt, clutch
* Not necessarily included in the scope of delivery!

12. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic. De-
fective components must be disposed of as special
waste. Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE).

13. Troubleshooting

Fault

Possible cause

The compressor • No supply voltage.
does not start.
• Insufficient supply voltage.
• Outside temperature is too low.
• Motor is overheated.
The compressor • The non-return valve leaks.
starts but there is no
pressure. • The seals are damaged.
• The drain plug for condensation water
(1) leaks.
The compressor • The hose connections have a leak.
starts, pressure is
shown on the pres- • A quick-lock coupling has a leak.
sure gauge, but the
tools do not start. • Insufficient pressure set on the pressure
regulator (7).
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
This product must be disposed of at a designated
collection point. This can occur, for example, by
handing it in at an authorised collecting point for the
recycling of waste electrical and electronic equip-
ment. Improper handling of waste equipment may
have negative consequences for the environment
and human health due to potentially hazardous sub-
stances that are often contained in electrical and
electronic equipment. By properly disposing of this
product, you are also contributing to the effective
use of natural resources. You can obtain information
on collection points for waste equipment from your
municipal administration, public waste disposal au-
thority, an authorised body for the disposal of waste
electrical and electronic equipment or your waste
disposal company.
Remedy
• Check the supply voltage, the power plug
and the socket-outlet.
• Make sure that the extension cable is not
too long. Use an extension cable with large
enough wires.
• Never operate with an outside temperature of
below +5° C.
• Allow the motor to cool down. If necessary,
remedy the cause of the overheating.
• Have a service centre replace the non-return
valve.
• Check the seals and have any damaged
seals replaced by a service centre.
• Tighten the screw by hand. Check the seal
on the screw and replace if necessary.
• Check the compressed air hose and tools
and replace if necessary.
• Check the quick-lock coupling and replace if
necessary.
• Increase the set pressure with the pressure
regulator.
GB | 21